As the manufacturer of slitting and rewinding machines, we sometimes get feedback of encountering issues with meter counters not functioning as expected. These problems can arise from both mechanical and electrical aspects of the machine.
Replacing the Programmable Logic Controller (PLC) of a paper sheeter is a crucial task that ensures the smooth functioning of the machine. However, this process
Top 4 problems during running thin food wrapping paper sheeter, wrinkle/curl/static/break…
Let’s know the differences of thermal paper mill and thermal paper processing factory today. Your will know what kind of machine to purchase after reading this blog.
Ways to avoid slitter rewind edge not even.
Buttons on control panel Operation process Inspection steps: Remark: machine operation side we mentioned above is the touch screen located side. The sensitive degree increases
You will know how to assemble and install the tag inserter device on a paper sheeter machine.
What’s the reasonable trim loss width?
For the slitting and rewinding machine, usually, the waste slit width is 8-20mm. If it is too narrow, it will be easy to tear down. If it is too broad, it will get stuck in the air tube.
It depends on the paper type. If the paper is very thick, it better reduces the trim loss width. Anyway, when the paper thickness is very thin and the stretch degree is very low. The trim edge width could increase a little. Typically more than 10mm.
For web guiding system, most often used is unwind guide. Let’s learn more about this system.
